Fog light switch harness install

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat Jul 12, 2014 7:56 am

Not familiar with 5th gen wiring unfortunately, but normally these original Honda instructions are very accurate, TbH.

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat Jul 12, 2014 9:37 am

That sounds like a plan

BTW, @nafemannathan might be interested to note the 10 amp AND 7.5 amp fuses in that particular pic...

Post by **NafemanNathan** » Sat Jul 12, 2014 4:00 pm

Ooo. Wouldn't want to remove the 7.5 amp fuse and see what stops working whilst you're there duckface would you?

In exchange I shall try an eye up where my fogs connect up. I've been working in that area recently. Although, if not to dissimilar the fog connections for a 4th gen are higher up.

I'll have a look though once I've finished doing what I'm doing

And cheers Iain

Post by **newkid** » Sat Jul 12, 2014 6:08 pm

edit

not sure what that first orange connector is for, see pics as per page 3 for the feed wire to the front fogs.

Post by **newkid** » Sat Jul 12, 2014 6:24 pm

duckface wrote:Yeah that's what I suspected however it's dead at the fog harness end...don't know if it's somehow been severed somewhere along its length

Edit, feedwire on page 3, orange wire black connector.

Post by **newkid** » Sat Jul 12, 2014 6:55 pm

That other connection will be for power.

Post by **NafemanNathan** » Sat Jul 12, 2014 10:50 pm

duckface wrote:Hey man, it's the 4ws / atts fuse...so should be redundant on yours At least, that's what it says on the cover I can still check to see what happens if you need, OK to let you know tomorrow?

No that's ok. I just assumed you were 2WS as Iain had drawn my attention to it. Mills had already identified it as an ATTS/4WS related fuse, just thought it may have been utilised for something if yours had been 2WS.

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sun Jul 13, 2014 12:53 am

Was I meant to be paying attention to who had 2ws or 4ws? I just saw an extra fuse and got excited!

Post by **newkid** » Sun Jul 13, 2014 12:08 pm

Updated, feed wire now been found, pics on page 3

Post by **newkid** » Sun Jul 13, 2014 2:36 pm

Hey bud, can u take a pic of the 2 plugs on the interior loom for me? Just so I have a reference of what type of plug im looking for, cheers.