Ideas For Frame/Stand For Club Banner

A1ex · Post by **A1ex** » Tue Feb 05, 2013 9:25 pm

Thanks for highlighting the key info so us old 5g drivers don't have to change our glasses.

I have access to a large amount of ABS, PVC, PE & PP pipe in sizes from 15mm to 300mm. Should be able to get all the bits together to make something to that effect...

NCCMUR · Post by **NCCMUR** » Tue Feb 05, 2013 9:26 pm

what merlin said

Post by **Gayno** » Tue Feb 05, 2013 9:27 pm

Wicked, it's just the corners that I'm thinking about, might look a bit chunky and look worse than if we didn't bother!

A1ex · Post by **A1ex** » Tue Feb 05, 2013 9:33 pm

I was think more goal posts and knock each end into the ground. Get matching elbows to go with the pipe too

Post by **NafemanNathan** » Tue Feb 05, 2013 9:33 pm

Reverse a 4th gen and a 5th gen towards each other 6 foot apart and pop the aerials up, job done

Post by **Merlin** » Tue Feb 05, 2013 9:35 pm

^ the 5th's aerial is built into the rear window

A 3rd an a 4th would work.

Post by **Gayno** » Tue Feb 05, 2013 9:37 pm

The weight of the banner would easily bend the aerials!

Post by **NafemanNathan** » Tue Feb 05, 2013 9:37 pm

Merlin wrote:^ the 5th's aerial is built into the rear window

Well that's stupid... How's Nitin supposed to get a JDM halfway switch for that?!

Post by **NafemanNathan** » Tue Feb 05, 2013 9:38 pm

Gayno wrote:The weight of the banner would easily bend the aerials!

I know Adam, I was being silly again

mercutio · Post by **mercutio** » Tue Feb 05, 2013 9:39 pm

NafemanNathan wrote:
Merlin wrote:^ the 5th's aerial is built into the rear window
Well that's stupid... How's Nitin supposed to get a JDM halfway switch for that?!

sew it to his pocket and leave it on half mast