Upgrade bits wanted for a 4th gen H22;
- Mugen or Tri-Y manifold/downpipe
OEM Red/Black interior
- JDM (no fog light cut out) rear bumper, paint colour unimportant
Plug with pigtails from any of the centre-console switches (e.g. front fogs, half mast switch etc)
Front undertray (with any fixings if poss) Looks like this;
Drivers side rear arch 'liner' (the small plastic trim bit that goes at the back of the arch between the bumper and the inner arch) Looks like this;
Both sides outer door seals (the one on the door that goes all over the top of the door frame)
Standard steering wheel with air bag and leather trim (replace the crap plastic one in the JDM), this might be from UKDM cars only?
Clips from the under bonnet sound deadener (round push in mushroom clips that hold it to the underneath of the bonnet) plus measurement of what size hole they go into
Spare wheel tool holder polystyrene insert (with tools if poss - pic nicked from Pushki);
Small plastic clip that holds the throttle cable onto the alternator wiring cover over the top of the rocker cover
Drivers side door lock jam (the hook bit that mounts on the B pillar)
UKDM fuse box complete (the one inside the cabin, drivers footwell)
JDM main instrument binnacle (the clock/fuel/temp gauge section). MUST be TCS version
All the oem bits in that list need to be in good/perfect nick as they're to replace bits we already have but 'aren't right'...
-----------------------------------------------------------------------------------------------------------------------------------
Bits I wanted but have now already got;
- Passenger side inner door seal (the one that goes on the shell up the B pillar, over the top and down the A pillar) - No longer required - Thanks JDM-BB4
white plastic insert for the vtec solenoid plug, goes in the plug in the pic below - complete plug cut off the loom and sent to me complete would be fine) - No longer required - Thanks jjmartin
Rad breather hose clip, unbroken) - No longer required - Thanks vanzep
Also need the bracket for this bit (fuel cutoff switch?) please - No longer required - Thanks Bludge and jjmartin
(Noticed that the bracket on the JDM has sheared, as shown here...)
Boot seal - No longer required - Thanks JDM-BB4
Mud flap screws (the stainless self-tappers that hold on the mud flaps, arch liners etc) - No longer required - Thanks JDM-BB4
UKDM sidelights (both sides) - No longer required - Bri has these for me, thanks
2x Door open switches - now got, thanks Jon
Door handle lock barrel trim, the rare design one - No longer required - vanzep has this for me, thanks
To help, this is the type I'm after the lock barrel trim for (this one has the trim bit missing)
Looks like this front on (with trim missing)
The 'normal' type handle looks like this (with the trim missing)
The difference in the trim piece I'm after is it's smaller and goes in from behind the handle, whereas the normal one (bottom pic) goes in from the outside
