BMCC'S 5G VTEC

BMCC · Post by **BMCC** » Sat Aug 04, 2012 2:10 pm

Update: New EBC front disks and yellow stuff pads

Old disks:

You can see the groove worn in the disks, probably caused by the sticking front calipers I had a few yrs ago now. Never noticed this when I changed the calipers

Update 2: New ignition leads blue Magnecor 8mm (photo to come due to car on jack!)

macky_6 · Post by **macky_6** » Sat Aug 04, 2012 8:30 pm

Looks good too

preludebaz1977 · Post by **preludebaz1977** » Sat Aug 04, 2012 9:50 pm

very nice mate and with leather too

BMCC · Post by **BMCC** » Sat Sep 29, 2012 4:43 pm

Update: Coilovers (d2's) and engine bay clean.

broken suspension look:

Front arch room:

Rear arch room:

Engine bay cleaned up:

Post by **Howzit37** » Sat Sep 29, 2012 6:03 pm

Awesome looking 5th, unusual leather, but I like it.

A1ex · Post by **A1ex** » Sat Sep 29, 2012 8:16 pm

Nice. Were the D2's on ebay?

nitin_s1 · Post by **nitin_s1** » Sat Sep 29, 2012 8:19 pm

Looks sooooo nice when it's low.

nice upgrade.

BMCC · Post by **BMCC** » Sun Sep 30, 2012 11:03 am

A1ex wrote:Nice. Were the D2's on ebay?

Yes they were!

Post by **Merlin** » Mon Oct 01, 2012 9:23 am

Nice! The car is looking good. Now I see why you need the 4WS locking pin

BMCC · Post by **BMCC** » Mon Oct 01, 2012 9:38 am

Merlin wrote:Nice! The car is looking good. Now I see why you need the 4WS locking pin

The handling feels ok but if you give it some revs with a bit of lock it feels like it is running on the edge of the tyre so I've been holding off testing the coilovers until I get the geometry set up properly. But the time is coming.....

Lude Generation

BMCC'S 5G VTEC

Re: BMCC 5G VTEC

Re: BMCC 5G VTEC

Re: BMCC 5G VTEC

Re: BMCC'S 5G VTEC