Magnecor HT leads

judderod · Post by **judderod** » Wed Jul 25, 2012 10:23 am

Seem to have developed a misfire, most likely due to the blueprint HT leads that don't fit properly

Had a look a new magnecors and the best price looks like £70 + £7 P&P from DC Performance

Anyone got some 2nd hand magnecors I could buy? Ideally red to match the rocker cover.

Post by **Lude-dude** » Wed Jul 25, 2012 11:09 am

I have some spare in red

but I took them off because think one of them kept popping up for whatever reason

not sure if it was not actually making a connection, but replaced them with some blue ngk anyway

you could have them for cheap

judderod · Post by **judderod** » Wed Jul 25, 2012 11:16 am

Lets talk

Are they defo the right ones for a H22? That sounds like the problem I have with my blueprint leads - the spark plug tube thingys aren't quite long enough to reach down over the spark plug tops without deforming the top part that seals over the hole.

Post by **Lude-dude** » Wed Jul 25, 2012 11:38 am

should be deffo h22,

they just lift up a little from the spark plug hole sometimes, I think with the pulling off and on the connections inside need squeezing together if you know what I mean lol

the rubber thingys seem fine when it stays on, but might be the same problem

judderod · Post by **judderod** » Wed Jul 25, 2012 12:04 pm

It might be worth me trying them just to see if it makes any difference, so I can check if the misfire is definitely HT lead related. Any chance of a pic & how much are you after? Might be best to PM.

Post by **NafemanNathan** » Wed Jul 25, 2012 1:03 pm

You guys know you can quite often pull the actual brass clip inside the rubber further through the rubber? I didn't know until Rich at PAW showed me as mine weren't gripping all that well. Now there's a real positive clip when you push them on

judderod · Post by **judderod** » Wed Jul 25, 2012 1:10 pm

Thx for the tip Nafe. I tried it but it didn't really work with my leads. I think they're about 2cm too short. I can pull the spark plug clip down the tube, but when I press the lead onto the plug, the clip just gets pushed back up the tube again

Post by **Lude-dude** » Wed Jul 25, 2012 2:14 pm

i'll get some pics when I get home tonight

judderod · Post by **judderod** » Wed Jul 25, 2012 2:20 pm

Thx matey

mills · Post by **mills** » Wed Jul 25, 2012 5:09 pm

Lude-dude wrote:should be deffo h22,

they just lift up a little from the spark plug hole sometimes, I think with the pulling off and on the connections inside need squeezing together if you know what I mean lol

the rubber thingys seem fine when it stays on, but might be the same problem

if they turn out to be no good, i may have a set available