5th Gen Bonnet Trim

toadster · Post by **toadster** » Mon Jun 18, 2012 4:41 pm

LO All 5th Genners

Just wondering how many 5th Gen owners still have the plastic trim attached at the front edge of their bonnets

Mine doesn't seem to sit straight at each end so i'm thinking of removing it.

Cheers

Toadster

Post by **RattyMcClelland** » Mon Jun 18, 2012 5:13 pm

You mean the seal on the headlight part of the bonnet?

CARRisma · Post by **CARRisma** » Mon Jun 18, 2012 5:20 pm

Think he's referring to the strip along the very front edge of the bonnet. I still have mine. I know USDM Ludes don't have it.

Post by **RattyMcClelland** » Mon Jun 18, 2012 5:23 pm

Never seen that before.
Why?
Because mine doesn't have it.
Seems like a rust catcher.

Post by **rob quilter** » Mon Jun 18, 2012 5:37 pm

Mine still has it on, I think its just secured with clips underneath. It doesn't do anything, so I'd remove it of its not on straight.

toadster · Post by **toadster** » Mon Jun 18, 2012 6:03 pm

LO All

TA for your replies

The trim just drops slightly at both ends as you can see on this pic , it's going a bit grey too , so i may remove and clean it up underneath.
I think it will look better.

Cheers

Toadster

Post by **rob quilter** » Mon Jun 18, 2012 6:07 pm

My trim doesn't pertrude out like that. You can't see my trim until you lift the bonnet.

toadster · Post by **toadster** » Mon Jun 18, 2012 6:47 pm

LO Rob

YEP i think there is a rubber seal plus this trim that has 5 clips holding it on that is made to fit around the bottom edge of the bonnet.
So i quess yours just has the rubber seal

maybe

Cheers

Toadster

nitin_s1 · Post by **nitin_s1** » Mon Jun 18, 2012 6:48 pm

I had that in my old UKDM motegi but not in the Type-S.

toadster · Post by **toadster** » Mon Jun 18, 2012 6:52 pm

LO

Trim mine has is part number 12
Rubber seal is part number 10

Cheers

Toadster

Lude Generation

5th Gen Bonnet Trim

5th Gen Bonnet Trim

Re: 5th Gen Bonnet Trim

Re: 5th Gen Bonnet Trim

Re: 5th Gen Bonnet Trim