Piston Rings H22? for less then 320 bucks?!

TheHondaTuner · Post by **TheHondaTuner** » Mon Apr 08, 2019 10:15 pm

Hey guys, where to get FRM usable piston rings for H22? I know there are civic sets for 80 bucks all 4 pistion but that a single piston on the h22 on ebay...

Post by **Drax** » Tue Apr 09, 2019 9:45 am

are these standard h22 piston rings your after bud?

TheHondaTuner · Post by **TheHondaTuner** » Tue Apr 09, 2019 10:53 am

Ah yes standart size

Post by **Drax** » Tue Apr 09, 2019 1:14 pm

https://h-tune.co.uk/npr-piston-rings-made-in-japan/

TheHondaTuner · Post by **TheHondaTuner** » Thu Apr 11, 2019 12:00 pm

Thanks for the Link, but iam confused what i get for 83€. Is it 1 pistion set or for all 4 pistions? I'll send a question to Htune

Post by **Drax** » Thu Apr 11, 2019 12:18 pm

TheHondaTuner wrote: ↑
Thu Apr 11, 2019 12:00 pm
Thanks for the Link, but iam confused what i get for 83€. Is it 1 pistion set or for all 4 pistions? I'll send a question to Htune

im pretty sure you'll get a set of 4x 3 ring sets for the whole lot - i know what you mean though as some sellers just sell one 3 ring set for 1x piston.

Scott560 · Post by **Scott560** » Thu Apr 11, 2019 2:14 pm

that is a set of 4 - you can tell, if you look at the oil control ring, there is more than 1 in there.

The last pack i opened were similar and had a set of 4 as pictured - about the same price if i recall...

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Fri Apr 12, 2019 11:33 am

Check down in the FAQ section a bit lower on the page, left hand side - question already asked and confirmed that it's the set of 4

TheHondaTuner · Post by **TheHondaTuner** » Fri Apr 12, 2019 3:19 pm

Much love guys. Thats good news. Now i need some advice about the crank/rod bearings! The H23 block iam going to use has 300.000km So replacing them might be a good thing. I know they have low tolerances, so iam afraid to make it worse. Wich from H-tune do the best job? Ive heard that new ones are marked how they go apart from the regular size, so i can put a little thicker one into the place where also a little thicker one was before. Is that true on ACL bearings also? And i have no clue about the options from Htune.. more oil clearance? Anything else I should know? Never touched a Honda crank before!

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Mon Apr 15, 2019 12:31 pm

That's a decent mileage on the engine, so yep probably is worth changing them.
Have you read up the oem service manual to find out the replacement procedure and sizing's? That's the place to start.