Meister R's onto a 4g

Post by **Drax** » Tue Apr 02, 2019 10:40 pm

anyone fitted these?

my fronts have 5 studs to fit at the top...

yet my chassis only has 3 holes...

Post by **RattyMcClelland** » Tue Apr 02, 2019 10:59 pm

Knock those 2 studs out. They are pressed it. I knocked mine out of my gt1s as not using my type S brace. However I knocked mine out when they were mounted which is very easy with a Timmy mallet.

Post by **newkid** » Wed Apr 03, 2019 8:22 am

As ratty says. Knock them out. For the standard 5th gen brace.

ATR84 · Post by **ATR84** » Wed Apr 03, 2019 8:33 am

I've had Meister R's on the 4th gen and 5th gen. Performance Autoworks set them up both times and didn't report any issues.

Post by **Drax** » Wed Apr 03, 2019 11:28 am

Brill thanks people! I suspected that was the case and tried gently knocking them with a mallet but didn't give it much force in case I was going down the wrong route!

Post by **tom023** » Wed Apr 03, 2019 1:13 pm

I didn't bother knocking mine out, I left them in and fitted them through the existing holes you have in the top of the strut tower in the picture you have uploaded.

Post by **Drax** » Wed Apr 03, 2019 1:32 pm

tom023 wrote: ↑
Wed Apr 03, 2019 1:13 pm
I didn't bother knocking mine out, I left them in and fitted them through the existing holes you have in the top of the strut tower in the picture you have uploaded.

as far as i can see, i dont have any holes in the chassis under the strut brace, otherwise i would have

Post by **newkid** » Wed Apr 03, 2019 4:01 pm

Drax wrote: ↑
Wed Apr 03, 2019 1:32 pm

tom023 wrote: ↑
Wed Apr 03, 2019 1:13 pm
I didn't bother knocking mine out, I left them in and fitted them through the existing holes you have in the top of the strut tower in the picture you have uploaded.
as far as i can see, i dont have any holes in the chassis under the strut brace, otherwise i would have

I see them. Under the loom.

M@dds · Post by **M@dds** » Wed Apr 03, 2019 4:44 pm

Those extra holes are for the type -S strut brace. as everyone else has said they are just covered holes.

Post by **Drax** » Wed Apr 03, 2019 5:00 pm

newkid wrote: ↑
Wed Apr 03, 2019 4:01 pm

Drax wrote: ↑
Wed Apr 03, 2019 1:32 pm

tom023 wrote: ↑
Wed Apr 03, 2019 1:13 pm
I didn't bother knocking mine out, I left them in and fitted them through the existing holes you have in the top of the strut tower in the picture you have uploaded.
as far as i can see, i dont have any holes in the chassis under the strut brace, otherwise i would have
I see them. Under the loom.

Yes, they are the holes for my Spoon brace as Modds- not in the chassis of the car