JDM Re-Bar anyone?

[thusee]

Anyone here using the JDM Rebar?

Not sure what your preludes come with if its the same as ours or the thin ones from japan, if you do do you notice a difference? I know there is a 30-40lb difference and is it worth doing the swap?

My car is not a daily, I probably put on about 100 km each month at most and mainly going to be focused on Track use going forward.

Thanks for any advice!

Stole this pic from another forum for reference:

[firstlude]

why do the swap just remove your current one and trim it down hay presto one light weight rear bar

[RattyMcClelland]

It's only a 5kg difference.

[nitin_s1]

I put a UKDM front end bar as the JDM one was too thin and got bent when someone decide to reverse in to me..

[thusee]

why do the swap just remove your current one and trim it down hay presto one light weight rear bar

The one on my car the tabs are all bent up, previous owner bent up the tabs to hold the headlights in place because the headlight tabs were broken.

So i need to replace the bar regardless LOL.....

It's only a 5kg difference.

only 5kg? thought it would be more...

I put a UKDM front end bar as the JDM one was too thin and got bent when someone decide to reverse in to me..

UKDM same as the bottom one in the picture i posted or is it different?

[nitin_s1]

Yes same as the bottom one pictured

[rrobis]

EDM preludes also have the bar like the top one, at least that's what I have and had to change after the crash. :/

[thusee]

hmm good to know