Polybushes set

Post by **NafemanNathan** » Mon Feb 20, 2017 3:47 pm

I have a feeling the S-Spec has the same front radius rod bushes as the Type-S. I'm sure @RattymcClelland and possibly even @Nitin_s1 will know.

If you do need them then give me a shout. I ordered a set thinking I needed them, waited over 2 months for them, only to find I didn't need them and already had the bushes I did need!

I imagine the lead time is still that long, so that'll save you a bit of a wait

nitin_s1 · Post by **nitin_s1** » Mon Feb 20, 2017 3:55 pm

S-Spec should have the same set as a normal Sir.. And last time I was looking for a set for my Type-S, the set was similar to the 4G one but only had a couple of bushing difference.

Post by **RattyMcClelland** » Mon Feb 20, 2017 6:00 pm

S spec is the same as all other 5th gens. Just Atts preludes have the 4 front lower ball joints.

Aaron14P · Post by **Aaron14P** » Wed Mar 01, 2017 8:42 am

only just seen these replies!! cheers @RattyMcclelland @nitin_s1 & @NafemanNathan will be ordering the polybush kit today.

so just to confirm this set will be fine for my lude -

http://www.strongflexuk.co.uk/honda/pre ... LaKwhicaCQ

Post by **NafemanNathan** » Wed Mar 01, 2017 8:54 am

Are you doing the whole car in Strongflex? How much does that come to?

Post by **RattyMcClelland** » Wed Mar 01, 2017 10:35 am

90a hardness.

My engine mounts are 75a and the whole car vibrates violently at low rpm.

Are those the correct roll bar sizes?

damon · Post by **damon** » Wed Mar 01, 2017 10:46 am

How long does it take for delivery?

Post by **NafemanNathan** » Wed Mar 01, 2017 10:47 am

Aaron14P · Post by **Aaron14P** » Wed Mar 01, 2017 11:06 am

I'm just doing the front for now, my mate reckons its about 4/5 hours work to remove and replace all the bushes at the front. the polybush set is £127 and then labour @NafemanNathan

I think thats the because its the sport set potentially, the other set is 80A - based on your response I imagine 80A is a better shout?

I've checked the front anti roll bar size online and it appears it is 25.4mm. -@RattyMcClelland

will let you know once I have ordered them bud - @Damon

Post by **NafemanNathan** » Wed Mar 01, 2017 11:09 am

Yeah, 90 shore could be a bit of an issue after not so long on our roads

Having said that I'm not entirely sure what Energy Suspension bushes are.