Injector Seals

Post by **Vtecmec** » Fri Sep 06, 2013 8:39 am

RattyMcClelland wrote:The link Vtecmec did on ebay doesnt include all of them

What do you think is missing?

Post by **RattyMcClelland** » Fri Sep 06, 2013 10:17 am

The small upper 0 ring? I'm not sure tbh. If that's all ill need then ill take the punt.
I have 3 intake manifolds with injectors still present to get used good gaskets off.

Post by **Vtecmec** » Fri Sep 06, 2013 10:44 am

I think that's all you need, but even if somethings missing, you can get that seperatly and save yourelf a fortune.

Post by **RattyMcClelland** » Fri Sep 06, 2013 1:56 pm

Problem is i need them ASAP. I cant wait to find out and then reorder.

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Sat Sep 07, 2013 10:23 pm

Hey Scott, got mine from here:

http://mrinjectoruk.co.uk/

Around £20 for all parts, but to be honest all you need is the upper O-rings (green) and the lower rubber seal. The rest you can re-use. But most sets come with other bits so you may as well switch them round.

From the link that was posted, that is everything. Above the two mentioned above, the thinner lower 'seal' is a plastic spacer for the injector to sit right. The thinner 'seal' with the flanges on the edges is an insulator to the top of the injector. Not sure why there is another set of O-rings in there (black). Final thing is replacement filters to sit in the top of the injector, but I couldn't remove one from my old injector. Maybe I was being too gentle, but didn't want to break it.

Post by **RattyMcClelland** » Sat Sep 07, 2013 10:44 pm

Yer its ok. I bought those off ebay.

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Sat Sep 07, 2013 10:50 pm

Cool.

mercutio · Post by **mercutio** » Sat Sep 07, 2013 11:38 pm

or you could have bought an engine gasket set it has the lot in there if I remember right

Metalhead · Post by **Metalhead** » Tue Jan 31, 2017 5:15 pm

RattyMcClelland wrote:So anybody else. The link Vtecmec did on ebay doesnt include all of them. Im leaning towards lashing out £90 to Honda.

[WARNING THREAD REVIVAL!]

I know this is some time ago but did you dins any alternatives to having your pants pulled down by Honda? I'm wanting to refresh the injector o-rings and collars/seats and although Honda still list them I'm also not that keen on shelling out £90 on some 5p rubber seals!!!

Any pointers would be useful!

Post by **RattyMcClelland** » Tue Jan 31, 2017 5:20 pm

Metalhead wrote:
Any pointers would be useful!

Got them from

Mrinjector