BB6 - Thusee from Toronto!

thusee · Post by **thusee** » Thu Aug 18, 2016 10:05 pm

Dennis van dijk wrote:How dig you restore them

Got a set to end need to be restored

Meguires ultimate compound with a microfiber pad

And then autoglym high resin polish with a polishing pad

Dennis van dijk · Post by **Dennis van dijk** » Sat Aug 20, 2016 2:33 pm

Thanks mate

thusee · Post by **thusee** » Mon Oct 03, 2016 3:20 pm

Haven't posted an update lately! Been a little busy but here are a few things i did in the last week

Had a mini meet and cruise!

Always wanted these rims and finally found a set for sale!
Advan SA3R

Mid Wing painted and Mid section dipped in some sort of CF weave (NOT MOUNTED)

Picked up a mint set of oem jdm fog lights!

nitin_s1 · Post by **nitin_s1** » Mon Oct 03, 2016 6:09 pm

Looks great.

Rudelude · Post by **Rudelude** » Mon Oct 03, 2016 6:12 pm

Nice pics, the ludes look good.. I like the front splitter too... Where did u get that from?

thusee · Post by **thusee** » Mon Oct 03, 2016 6:33 pm

nitin_s1 wrote:Looks great.

Thanks!

Rudelude wrote:Nice pics, the ludes look good.. I like the front splitter too... Where did u get that from?

Found them on a part out haha, I need to re mount them by angling them out a little more.

Rudelude · Post by **Rudelude** » Mon Oct 03, 2016 10:57 pm

Goood find... I like the overall look

thusee · Post by **thusee** » Thu Oct 06, 2016 7:30 pm

Got some more goodies in the mail

thusee · Post by **thusee** » Mon Oct 10, 2016 5:57 am

Started on trying to figure out where to mount the edfc unit. Most people put it in the pocket below the fog/dimmer/cruise switches are but I have the usdm 5 plug bezel and all switches are used.

5th gen ludes don't have a solid place to mount stuff unless i downgrade to a single din radio and get a single din pocket below the radio....after a lot of consideration i think i found the perfect spot. Let me know your thougts!

On the radio bezel to the left of the cig lighter i thought it was perfect...

After taking the bezel off this is what is left with:

Drilled a bunch of holes:

Cut it out then dremeled the edges smooth:

Test fit without bezel:

I have started on the Bezel drilled about 8 holes, will post more pics of install as it gets under way this week.

thusee · Post by **thusee** » Thu Oct 13, 2016 2:43 pm

Controller is mounted in the bezel and came out exactly how i expected. Now just need to run all the wiring and swap the coil overs

.

Lude Generation

BB6 - Thusee from Toronto!

Re: BB6 - Thusee from Toronto!

Re: BB6 - Thusee from Toronto!

Re: BB6 - Thusee from Toronto!

Re: BB6 - Thusee from Toronto!

Re: BB6 - Thusee from Toronto!

Re: BB6 - Thusee from Toronto!