where is the 2 pin abs wire located

preludemanh22 · Post by **preludemanh22** » Sat Jul 16, 2016 2:28 pm

abs light on need to do a test any help appreciated

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat Jul 16, 2016 2:30 pm

Drivers footwell, up behind the stereo.

preludemanh22 · Post by **preludemanh22** » Sat Jul 16, 2016 2:44 pm

Thanks mate u have to remove anything and just bridge a paper clip in the 2 connectors ?

Thank u

preludemanh22 · Post by **preludemanh22** » Sat Jul 16, 2016 3:24 pm

Would it be the blue connector going into grey connector or the yellow which is not connected ?

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat Jul 16, 2016 4:51 pm

It's a blue 2 pin connector. It won't be connected to anything, but you may find it plugged in to a dummy holding socket.

preludemanh22 · Post by **preludemanh22** » Sat Jul 16, 2016 8:12 pm

unplugged that then put it back now no abs light on

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sun Jul 17, 2016 8:39 am

Did you not pull the codes?

preludemanh22 · Post by **preludemanh22** » Sun Jul 17, 2016 10:11 am

No i wasn't sure what one it was so just put it back and since I've been out and it's gone off

Post by **Vtecmec** » Sun Jul 17, 2016 11:00 am

Well fixed.

preludemanh22 · Post by **preludemanh22** » Sun Jul 17, 2016 11:04 am

Yer