Honda-Hardy's type "s" express

Rudelude · Post by **Rudelude** » Tue May 03, 2016 8:45 pm

It looks amazing... Are those the motegi sides U have? Or wings west?

Post by **Andy1000** » Tue May 03, 2016 11:56 pm

The alloys on your car is that the standard speed line motegi wheels painted black as they look awesome

The "S" express · Post by **honda-hardy** » Wed May 04, 2016 11:45 am

Yes standard motegi 17 inch alloys painted black. Also wings west skirts.

Post by **SPYDOR** » Wed May 04, 2016 12:14 pm

prahunt wrote:Carbon wrap looks really good.
Nice tip on the fairy up liquid as well. Do you then just squeeze it out, or let it dry once the wrap is in position?

You can use any detergent for the purpose, same as applying window tints. A spray-bottle using water mixed with 2-3 drops of baby lotion also works brilliantly. You need to squeegee all the bubbles out and most of the water will be pushed out at the same time. The film dries on a thin surface of water which slowly dries out after a few days.

bb1boy · Post by **bb1boy** » Mon May 09, 2016 11:38 am

As Nitin said, the wrap on the rear spoiler really ties it with the front hood spoiler.

..I wonder how much it'd cost for a real carbon insert piece to be made??

CARRisma · Post by **CARRisma** » Wed May 11, 2016 1:13 pm

honda-hardy wrote:@Musashi here is how i sorted out my pcv pipe. as i had to replace the angle intake pipe due to splittings i have now just drilled a hole into it and fitted some silicone hose to a piece of aluminium tube.

Post revival time!

@honda-hardy have you got any info on the pipe you used such as a link or specs? I assume it already have an curve in it? I need to replace mine and I would prefer not to waste money through trial and error!

The "S" express · Post by **honda-hardy** » Wed May 11, 2016 11:53 pm

I used 76mm internal diameter silicon hose at a 45 degree angle. However the angle is more than 45 degrees as it kinks slightly so perhaps go for a 60 degree bend instead. Also don't use cheap hose. It sucks in on itself under load.

CARRisma · Post by **CARRisma** » Thu May 12, 2016 8:22 am

honda-hardy wrote:I used 76mm internal diameter silicon hose at a 45 degree angle. However the angle is more than 45 degrees as it kinks slightly so perhaps go for a 60 degree bend instead. Also don't use cheap hose. It sucks in on itself under load.

Wonderful, thanks for that.

Post by **JEBB4** » Sat May 14, 2016 7:15 am

This car is such a beut!! Quite fancy a 5g now

The "S" express · Post by **honda-hardy** » Sun Jul 17, 2016 5:01 pm

Cheers for your great compliment.

Lude Generation

Honda-Hardy's type "s" express

Re: Honda-Hardy's type "s" express

Re: Honda-Hardy's type "s" express

Re: Honda-Hardy's type "s" express