Wanted-4th gen h22a rear engine mount

Post by **Greg-SiR** » Thu Mar 10, 2016 11:58 am

Just wondering would fitting the es poly inserts cover up fatigue from the old mounts?
I know my bb2 has some vibration but yet to diagnose which are gone and considering something like these inserts to see me through a test for roadworthiness and obviously lessen the movement.
Looking at $100Ausd for the set delivered through the Co's website which is what it nearly cost for 2 mounts i bought for my other lude.

Post by **Merlin** » Thu Mar 10, 2016 12:32 pm

Greg-SiR wrote:Just wondering would fitting the es poly inserts cover up fatigue from the old mounts?

Yes, it is pretty much the only reason to use them.

Post by **vanzep** » Thu Mar 10, 2016 3:21 pm

got to say i do like the sikaflex filled mounts on my BB4 - have done all four this way-increased vibration in the cabin but a far more direct feel to car as a whole - i guess more energy goes to the wheels quicker rather than bouncing the engine all over the place

GJMHONDA2012 · Post by **GJMHONDA2012** » Thu Mar 10, 2016 5:20 pm

vanzep wrote:got to say i do like the sikaflex filled mounts on my BB4 - have done all four this way-increased vibration in the cabin but a far more direct feel to car as a whole - i guess more energy goes to the wheels quicker rather than bouncing the engine all over the place

I couldn't get any sikaflex at short notice so I actually used tiger seal for the front mount, does exactly the same and I must admit the difference is unreal but like u say the vibration in the cabin is abit annoying but I can live with that and the pull when u accelerate is far better and no juddering when pulling off

Post by **vanzep** » Sat Mar 12, 2016 6:33 pm

rear mount posted out to you today 1st Class via Royal Mail