4th gen bits for sale/updated with more parts 17/1/16

alinton · Post by **alinton** » Sun Dec 06, 2015 2:34 am

Fitting rear high level brake light: pull off rear plastic ceiling trim panel, it clips off.

The brake light fixes with two bolts, M6 I think. If you're lucky, your car will have a wiring loom and plug sitting there waiting for the brake light. If not you'll have to run a wire from it down the pillar, into the boot and connect to a brake light there.

The new roof trim clips back on, then the internal cover for the brake light clips on.

GJMHONDA2012 · Post by **GJMHONDA2012** » Sun Dec 06, 2015 12:22 pm

Bump any offers

GJMHONDA2012 · Post by **GJMHONDA2012** » Wed Dec 09, 2015 8:25 pm

GJMHONDA2012 · Post by **GJMHONDA2012** » Sat Dec 12, 2015 4:56 pm

Post by **vanzep** » Sat Dec 12, 2015 10:03 pm

what happened to my inquiry on the drivers side window switch

i never heard back from you - yet you seem to have plenty of time to constantly bump this thread

GJMHONDA2012 · Post by **GJMHONDA2012** » Sat Dec 12, 2015 10:37 pm

vanzep wrote:what happened to my inquiry on the drivers side window switch
i never heard back from you - yet you seem to have plenty of time to constantly bump this thread

sorry mate completely forgot about switches

Post by **vanzep** » Sat Dec 12, 2015 10:45 pm

GJMHONDA2012 · Post by **GJMHONDA2012** » Sat Dec 12, 2015 11:43 pm

vanzep wrote:

make me an offer on the switches mate, is it both sides ur after??

Post by **vanzep** » Mon Dec 14, 2015 3:14 pm

Sorry bud - i put an offer in on one on ebay and was waiting to hear back - the offer has been accepted so got it sorted

GJMHONDA2012 · Post by **GJMHONDA2012** » Mon Dec 14, 2015 4:35 pm

vanzep wrote:Sorry bud - i put an offer in on one on ebay and was waiting to hear back - the offer has been accepted so got it sorted

ok mate no worries

Lude Generation

4th gen bits for sale/updated with more parts 17/1/16

Re: 4th gen bits for sale