5th gen Carbon Fibre cooling plate V2 installed (7 new pics)

stk prelude · Post by **stk prelude** » Fri Apr 13, 2012 8:20 pm

Looks way better mate, looks very sexy

mercutio · Post by **mercutio** » Fri Apr 13, 2012 11:30 pm

that looks much better

A1ex · Post by **A1ex** » Sat Apr 14, 2012 7:18 am

Cheers folks

Is there anymore interest now?

I've refined the process and can make them within a couple hours now so happy to do them for £40 each + P&P

Also, had my usual freaking insane drive to work this moring at 6am and I think it definately helps with the cooling. Usually when I pull up at the lights I get the smell of hot engine components in the cabin but nothing today

Post by **lewd lude lover** » Sat Apr 14, 2012 9:21 am

the original designs fixing points have not been used on either finished design yet. this is a big disability for the part as no one has seen how it is supposed to sit on the car when actually in place. it either looks sloppy and floppy or unable to achieve a seal

shame really.

this is no7 template while not attached on the front bolts. hopefully you can see that the rear fixing points mean the part sits flat against the car and is also enclosing 100% of the rad. this was how the design was suppose to work. both horns have been relocated to give a better seal and the whole part blends with the cars lines.

ill be seeing you later alex

carbon goodies and tein shall be swapped!!!

A1ex · Post by **A1ex** » Sat Apr 14, 2012 9:25 am

^^^ good point. We'll get some installed photos of LLL's setup too and see how it looks. I'm sure it'll look better without my rusty slam panel in the shot thats for sure!

Post by **lewd lude lover** » Sat Apr 14, 2012 10:50 am

hey alex, i got trapped in the 'girlfriend time vortex' this morning. as such i will be setting off in about half an hour rather than 40 mins ago

and no im not using nice words to say i got laid. iv just been to a weigh station to weigh a horsebox

A1ex · Post by **A1ex** » Sat Apr 14, 2012 11:06 am

V2 is excatly the same as the original but mounted under the hood assy instead of over so it's a versatile part

We'll take a look at mine with it mounted the other way and see how it looks

Post by **lewd lude lover** » Sat Apr 14, 2012 11:12 am

leaving now. 1pm arrival abouts

Iv_vick · Post by **Iv_vick** » Tue Nov 03, 2015 8:11 pm

Does anybody here still interested in manufactured cooling plate?

Iv_vick · Post by **Iv_vick** » Fri Nov 06, 2015 6:25 pm

I made a few, looks exactly like here: