Big big big Help needed JRSC GUYS!! :(

mercutio · Post by **mercutio** » Fri Sep 18, 2015 2:11 pm

NafemanNathan wrote:Hard to tell from that first photo, but is it once piece of two? Have you got a picture of the side?

If it can be made of two plates (bolted together) I can't get it done for a fraction of that!

what are we talking about???

Post by **NafemanNathan** » Fri Sep 18, 2015 2:13 pm

This!...

This is what he wants reproduced right?

mercutio · Post by **mercutio** » Fri Sep 18, 2015 2:16 pm

yep thats right

mercutio · Post by **mercutio** » Fri Sep 18, 2015 2:18 pm

thats fine i will get my engineer to stop now and get my bit back and stick it on my car

if you can let woot know when you can get it done

Post by **NafemanNathan** » Fri Sep 18, 2015 2:20 pm

mercutio wrote:thats fine i will get my engineer to stop now and get my bit back and stick it on my car if you can let woot know when you can get it done

NafemanNathan wrote:@mercutio, if you can photocopy it and then scribble some exact dimensions between hole-centres that I can then use for reference, then include the plate thicknesses, I can get them laser cut for woOtSalami.

mercutio · Post by **mercutio** » Fri Sep 18, 2015 2:22 pm

thats just the bracket thats not the little piece of wierdly shaped aluminium

Post by **NafemanNathan** » Fri Sep 18, 2015 2:26 pm

mercutio wrote:thats just the bracket thats not the little piece of wierdly shaped aluminium

Which piece is that, the "Lower Support Bracket"?

Post by **NafemanNathan** » Fri Sep 18, 2015 2:27 pm

Also it looks like it's made of steel???

mercutio · Post by **mercutio** » Fri Sep 18, 2015 2:35 pm

see the little bit bolted to the bracket?

mercutio · Post by **mercutio** » Fri Sep 18, 2015 2:36 pm

thats anodised black but its not steel