Big big big Help needed JRSC GUYS!! :(

woOtSalami · Post by **woOtSalami** » Sun Sep 06, 2015 12:14 pm

@NafemanNathan That would be super nice! It's a pain without these plates. Belt Slip and if you tighten too strong it will drift on the oustide and destroy itself.

@mercutio Yay

Keep me informed what the status is. Can't wait to have them and kick some more boost on it

@RattyMcClelland The idea is really good but in my opinion it would also be worth it to recreate the pulleys and jackshaft housing. basically everything.

woOtSalami · Post by **woOtSalami** » Tue Sep 08, 2015 7:29 pm

So I need to aks another thing. Could we also recreate the jackshaft holder?

this one:

and how is the progress on the alternator bracket?

@mercutio

mercutio · Post by **mercutio** » Wed Sep 09, 2015 9:20 pm

that would be expensive in billet buddy and i mean expensive i am going to see my engineer tomorow

woOtSalami · Post by **woOtSalami** » Sun Sep 13, 2015 9:44 pm

@mercutio any news? need it asap :/

mercutio · Post by **mercutio** » Thu Sep 17, 2015 5:43 pm

My Engineer has said to reproduce it as a one off it will be £100 let me know quickly as i need the bit back to fit mine @woOtSalami

woOtSalami · Post by **woOtSalami** » Fri Sep 18, 2015 12:57 pm

@mercutio do it! send me ur paypal adress and the money will be asap at your acc.

mercutio · Post by **mercutio** » Fri Sep 18, 2015 2:04 pm

this is just for the bracket and piece of aluminium that started this thread yes? i know we cant reproduce the other bit without it being mega expensive

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Fri Sep 18, 2015 2:06 pm

mercutio wrote: let me know quickly as i need the bit back to fit mine

mercutio · Post by **mercutio** » Fri Sep 18, 2015 2:07 pm

Post by **NafemanNathan** » Fri Sep 18, 2015 2:09 pm

Hard to tell from that first photo, but is it once piece of two? Have you got a picture of the side?

If it can be made of two plates (bolted together) I can't get it done for a fraction of that!