Big big big Help needed JRSC GUYS!! :(

mercutio · Post by **mercutio** » Wed Sep 02, 2015 10:51 pm

thought you took it off?????

woOtSalami · Post by **woOtSalami** » Wed Sep 02, 2015 11:16 pm

@mercutio

So if you can get them done perfectly in the way like the Originals are then i would appreciate it. Just Tell me how long IT would take and how much u get from me

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Wed Sep 02, 2015 11:30 pm

RattyMcClelland wrote:I can't measure mine. They are on the car.

Meh, that's boring - that's exactly what everyone expects you to do with car parts!

Post by **RattyMcClelland** » Thu Sep 03, 2015 12:11 am

mercutio wrote:thought you took it off?????

The main charger part if off but the brackets etc are still on. Big ball ache removing them when the car can run fine with them on until its all ready to go back on.

woOtSalami · Post by **woOtSalami** » Fri Sep 04, 2015 12:23 pm

up! urgent

Post by **NafemanNathan** » Fri Sep 04, 2015 12:52 pm

@mercutio, if you can photocopy it and then scribble some exact dimensions between hole-centres that I can then use for reference, then include the plate thicknesses, I can get them laser cut for @woOtSalami.

Post by **RattyMcClelland** » Fri Sep 04, 2015 1:14 pm

NafemanNathan wrote:@mercutio, if you can photocopy it and then scribble some exact dimensions between hole-centres that I can then use for reference, then include the plate thicknesses, I can get them laser cut for @woOtSalami.

Might be worth making a few sets. A few yanks requires them too.

Post by **NafemanNathan** » Fri Sep 04, 2015 1:28 pm

RattyMcClelland wrote:
NafemanNathan wrote:@mercutio, if you can photocopy it and then scribble some exact dimensions between hole-centres that I can then use for reference, then include the plate thicknesses, I can get them laser cut for @woOtSalami.
Might be worth making a few sets. A few tasks requires them too.

It'd be a case of just keeping it on file, so anyone anytime can just ask me for a set. There's no machining involved right, just two flat plates with holes in?

mercutio · Post by **mercutio** » Fri Sep 04, 2015 2:25 pm

nope one flat plate the other is a bit of machined aluminium i am going to see the engineer this weekend if he is in i will have to call him today after jury service

Post by **NafemanNathan** » Fri Sep 04, 2015 2:35 pm

Post up some pics of various angles of each piece if you get chance Merc.