Dizzy Part - Any Honda

Post by **Vtecmec** » Thu Sep 03, 2015 12:27 pm

Hey, I am after the part of the dizzy that sits into the cam to drive it, I think they are all the same on all honda dizzys.

The bit with the lugs as pictured here.

Desperate (typical pre JAE) for one ASAP.

Cheers in advance.

Post by **vanzep** » Thu Sep 03, 2015 3:08 pm

Ive got a newly refurbed dizzy that failed when fitted - was too good to throw away but prob needs a new igniter pack.
So its sitting there ready to be fixed or for use as spare parts - do you want the whole dizzy or how easy is it to take the cam key spindle off that you are looking for

Post by **Vtecmec** » Thu Sep 03, 2015 3:42 pm

The part comes off quite easily (remove circlip and push a pin out).

Out of interest, what would you want for the whole dizzy? Or just the lug hub?

Post by **vanzep** » Thu Sep 03, 2015 5:06 pm

tbh it would be easier if you took the whole disti - i did get a 50% refund from the seller - so its still due me £20

if you can cover that id be happy

Post by **Vtecmec** » Thu Sep 03, 2015 5:19 pm

Done, I'll take it thanks. Any chance you can post it ASAP, with a fast delivery? Postage cost isn't an issue. Let me know your PayPal and the postage cost and I'll send you some cash. Cheers.

Post by **vanzep** » Thu Sep 03, 2015 5:51 pm

no worries will get it sent out tomorrow - just drop me a note of your full name and address

h10ndr · Post by **h10ndr** » Thu Sep 03, 2015 6:18 pm

obviously I don't need to tell you vtecmec

, but you can obviously replace this 180' out, so make sure to mark the end of the shaft in relation to the part (as in your pic) then you can orientate the new part in the same way...

See ya all at JAE next week....

Post by **vanzep** » Thu Sep 03, 2015 6:25 pm

Post by **Vtecmec** » Thu Sep 03, 2015 6:46 pm

h10ndr wrote:obviously I don't need to tell you vtecmec , but you can obviously replace this 180' out, so make sure to mark the end of the shaft in relation to the part (as in your pic) then you can orientate the new part in the same way...

See ya all at JAE next week....

Indeed, that fact may be the very reason why it has failed.

alinton · Post by **alinton** » Fri Sep 04, 2015 5:33 pm

I've a dead dizzy too, if anyone wants it. Cam sensor failed.