hesitation issues (again) on my H2B swap HELP......

Post by **Vtecmec** » Sun Jun 28, 2015 7:16 pm

Better, though double check the blue hose on the left, as that normally goes to the EVAP canister, and i think it should come from one of the outlet that you have blocked off with the blue u bend at the back just behind the throttle body. I'm not sure if that'll make any difference though.

hoppi05 · Post by **hoppi05** » Sun Jun 28, 2015 8:01 pm

thanks buddy i have been using this diagram from the manual to help me if people could help configure what i have below?

Post by **Vtecmec** » Sun Jun 28, 2015 8:14 pm

Yes, block the cruise control actuator.

Might be worth getting a constant vacuum control unit, though I don't think it is too critical.

hoppi05 · Post by **hoppi05** » Sun Jun 28, 2015 8:43 pm

from what i can see my b16 evap does not have the hose 3 connection its only got the two connections one to the throttle body and the other which goes off back under the car i assume to the tank, so 3 leads to purge control valve and that goes into 20 to the connector on the top of the throttle body one of the two facing the wind screen. based on me not having that should i block it off? or do i need that part?

hoppi05 · Post by **hoppi05** » Sun Jun 28, 2015 8:46 pm

i am also missing CVC which is line 24 coming from the righthand side two connectors next to the cruise control line again should i block this or do i need that part?

cheers guys

hoppi05 · Post by **hoppi05** » Sun Jun 28, 2015 8:47 pm

and again i am missing the intake control solenoid line 8 as above do i need this part or can i block it off?

cheers

hoppi05 · Post by **hoppi05** » Sun Jun 28, 2015 9:14 pm

so from looking at images online mostly in the states i can see the loop we have on the rear two connectors 20 & 8 this just leaves 24?

Post by **Vtecmec** » Sun Jun 28, 2015 9:26 pm

24, Block it off.

hoppi05 · Post by **hoppi05** » Sun Jun 28, 2015 10:08 pm

Will do god I cannot wait to try straight after work tmoz

Post by **vanzep** » Mon Jun 29, 2015 8:55 am

weve been feeling your pain on this build buddy...hope this will work out well for you today

Lude Generation

hesitation issues (again) on my H2B swap HELP......

Re: hesitation issues (again) on my H2B swap HELP......