BB6 - Thusee from Toronto!

thusee · Post by **thusee** » Sat May 23, 2015 10:23 pm

Switched out the right front fender cover and lower front cover as the old one was destroyed from bottoming out a couple of times haha....

decided to switch out my fog lights to purple fogs for a change haha....

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sun May 24, 2015 10:02 am

That's some serious painting you're doing there! Fair play!

thusee · Post by **thusee** » Sun May 24, 2015 1:27 pm

Haha figured might as well do some undercoating while bodypanels are off the door.

about to start on the car again in an hour and hoping to get a lot more done. My goal is to finish it by next Friday and put it back on the road!

thusee · Post by **thusee** » Sun May 24, 2015 8:06 pm

So did some re wiring today. Made my sidemarkers that are on the side of the bumper blink with the blinkers and also alternate when the lights are on.
Here's a little clip

Also my driverside headlight had a broken tab that attaches to the side fender so i hacked off what was left...
This was after i cut off the broken tab and straigthened it:

Donor light on the floor

Here's the part i needed which i cut off the donor light.

JB Weld and a metal bracket:

thusee · Post by **thusee** » Wed May 27, 2015 9:55 pm

Got my front fenders mounted

and lined up with the bumper and headlights. (Bumper wasn't secured it was just put in for alignment) Also started the front lights restoration, I have finished 1 out of 6 lights. ( 2 headlights and 2 fog lights and 2 signals)

Pictures of the lights:
Before:

After:

thusee · Post by **thusee** » Thu May 28, 2015 1:44 pm

More work was done!

Restored both side fog lights and turn signals

Installed bumper just to test out all the lighting

Post by **Vtecmec** » Thu May 28, 2015 2:23 pm

Nice.

mercutio · Post by **mercutio** » Thu May 28, 2015 5:32 pm

well done buddy

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Thu May 28, 2015 5:45 pm

Sparkly

thusee · Post by **thusee** » Wed Jun 03, 2015 8:22 pm

Thanks guys

So i started on the headlights and managed to finish one side and ran out of materials

so that was put on pause.

In the mean time i pulled out all my speakers and deck as i was going back to stock setup except for the deck. Re did the radio harness so its plug and play and started pulling out the amp and speaker wiring.

Should finish up with the wiring removal today then install the deck and panels back on. Finally able to get some trunk space back haha.

Lude Generation

BB6 - Thusee from Toronto!

Re: BB6 - Thusee from Toronto!

Re: BB6 - Thusee from Toronto!

Re: BB6 - Thusee from Toronto!

Re: BB6 - Thusee from Toronto!

Re: BB6 - Thusee from Toronto!

Re: BB6 - Thusee from Toronto!