4ws steering angle sensor question

johnierice · Post by **johnierice** » Wed Apr 29, 2015 10:47 pm

flashcode 21 has popped up which is main Steering Angle sensor. Has anyone changed one of these and did it cure the problem or can I adjust/reset it on the steering column?

Post by **Vtecmec** » Wed Apr 29, 2015 10:58 pm

You can adjust it if you take the steering wheel off.

http://www.ludegeneration.co.uk/honda-p ... =alignment

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Wed Apr 29, 2015 11:45 pm

Is it the same on 5g's?

Post by **Vtecmec** » Thu Apr 30, 2015 9:08 am

Oh, good point.

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Thu Apr 30, 2015 9:33 am

Assuming the profile panel is correct of course...

johnierice · Post by **johnierice** » Thu Apr 30, 2015 11:22 pm

It is a 5g, from what I have read it's not adjustable apparently, will pull it off and have a look this weekend.

If I can adjust it what shall I actually do? Just move it about and keep trying the ignition on?

Post by **Lude-dude** » Fri May 01, 2015 10:22 am

I would try to replace the sensor...

problem is finding one and removing one

don't think anyone on the forum has successfully fixed this code before

johnierice · Post by **johnierice** » Sat May 02, 2015 7:48 pm

I'll have a good go at being the first then!

bennyboy · Post by **bennyboy** » Sat May 02, 2015 9:05 pm

Lude-dude wrote:I would try to replace the sensor...

problem is finding one and removing one

don't think anyone on the forum has successfully fixed this code before

Really? I'm intrigued now, what's the issue?

hondansxr · Post by **hondansxr** » Sun May 03, 2015 5:42 pm

50 ....actual rear steering angle too high
20.... front main/sub steering angle sensor outputs
these are my fault codes love to know if you fix yours