ATR gearbox

damon · Post by **damon** » Sat Oct 25, 2014 7:22 pm

Hello, I have just picked up my ATR gearbox plan to fit it next week, is there anything I need before I start? Or any seals that could need replacing? Thanks guys

Post by **RattyMcClelland** » Sat Oct 25, 2014 7:23 pm

Main real oil seal wouldnt hurt being replaced.

YouTube · Post by **Sailor** » Sat Oct 25, 2014 11:50 pm

RattyMcClelland wrote:Main real oil seal wouldnt hurt being replaced.

??

Cutz · Post by **Cutz** » Sun Oct 26, 2014 3:18 am

RattyMcClelland wrote:Main real oil seal wouldnt hurt being replaced.

+1.

if there's any signs of weepage change it while you have a chance.

same goes for the clutch...inspect it throughly before refitting.

as for the gearbox, make sure you have the right Honda MTF to go in and dont forget you'll need the ATR VSS sensor to hook it all up right.

damon · Post by **damon** » Sun Oct 26, 2014 8:37 am

Great thanks, I'll order some oil the vss is with the box, the clutch has only done a few thousand miles. Where is best to get the seals from?

Post by **Thebusofwoe** » Sun Oct 26, 2014 9:05 am

Also the cv joint gearbox seals. Cheap, I would do those.

Post by **RattyMcClelland** » Sun Oct 26, 2014 11:26 am

Get all from Honda.

damon · Post by **damon** » Fri Nov 28, 2014 12:00 pm

Good morning all, am having the ATR box fitted on Monday, iv been reading up on here something about having to change the vss over? What do I need to do?

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Fri Nov 28, 2014 2:58 pm

Take the VSS out of your current box, take the existing one out of the ATR box and put the lude VSS into the ATR box, I think?

Is that right?

*blindly over-reaches and stabs in the dark...*

damon · Post by **damon** » Fri Nov 28, 2014 5:26 pm

Ok great thanks