Rob's BB6 JDM SiR - Written Off.

Post by **rob quilter** » Wed Jul 02, 2014 8:31 pm

Yeah I am. It needs a few bits doing though.

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Wed Jul 02, 2014 9:19 pm

That parcel shelf rework sure was a little bit dodgy looking! Parts stash to the rescue...

mart609 · Post by **mart609** » Wed Jul 02, 2014 11:04 pm

Looks mint mate!
Love it!

crigal.bb6 · Post by **crigal.bb6** » Thu Jul 03, 2014 4:14 pm

I wondered who bought this. You beat me to it. When I rang the guy he broke my heart lol.

Post by **RattyMcClelland** » Thu Jul 03, 2014 7:02 pm

crigal.bb6 wrote:When I rang the guy he broke my heart lol.

Did he tell you Nitins "size" too?

nitin_s1 · Post by **nitin_s1** » Thu Jul 03, 2014 10:42 pm

Post by **rob quilter** » Fri Jul 04, 2014 6:27 pm

Tinted my foglights yellow today (Didn't get any pics).

I also fitted some new front discs and pads aswell.

I ordered 2 new Toyo tyres for the rear that came today, I have it booked in at my usual tyre place tomorrow to have them fitted and the tracking done.

Post by **rob quilter** » Sun Jul 06, 2014 10:33 am

Well since I bought the car its vibrated under acceleration, it goes as soon as you put it into neutral or drop the clutch. So its obviously either the CV driveshafts or engine mounts, I've rocked the engine and it doesn't really move, so I'm going to replace the inner driveshafts.

On the plus side it had 4 new tyres yesterday along with tracking.

Post by **rob quilter** » Mon Jul 14, 2014 2:39 pm

I can 99% sure say that my vibration issues are coming from worn inner CV joints. I have ordered 2 new ones, I have also ordered 2 outer ones and I will refurbish the complete driveshafts including a lick of fresh paint.

Pics after yesterday's clean:

I removed the Type S badge, but it lefty loads of sticky crap that I could clean off. So I stuck it back on and I will pick up some sticky stuff remover some point this week to remove the sticky residue.

Front fogs tinted yellow:

Sven · Post by **Sven** » Mon Jul 14, 2014 3:27 pm

About the rear shelf, I had the same thing, the 3rd breaklight is in my spoiler and also had a 3rd breaklight not wired up on the rear shelf. So i took out the rear shelf, bought some speakerbox fabric and covered the whole thing up and stapled it at the sides which aren't visible when you put the deck back in. It really looks like new. There's a pic in my topic, first page.
http://www.ludegeneration.co.uk/profile ... 13133.html

It took me about 2 hours to do this, and it costed my like £10.

Cheers Sven

Lude Generation

Rob's BB6 JDM SiR - Written Off.

Re: Rob's BB6 JDM SiR

Re: Rob's BB6 JDM SiR

Re: Rob's BB6 JDM SiR - Vibration Woes :(

Re: Rob's BB6 JDM SiR - Vibration Woes :(