custom h22 intake mani

Post by **Drax** » Tue May 27, 2014 10:17 pm

http://www.ebay.co.uk/itm/261489357502? ... 1423.l2649

mercutio · Post by **mercutio** » Tue May 27, 2014 10:21 pm

I suppose it might be ok for small boost but will lose power without a map n/a

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Wed May 28, 2014 12:12 am

Looks like a lot of effort when you should just fit a skunk or ATR one instead?

Post by **cebul** » Wed May 28, 2014 4:37 am

ATR manifold also require some work before it is fitted

Post by **NafemanNathan** » Wed May 28, 2014 4:22 pm

Why on earth would you weld that direct to the IM lower?! Weld it to a flange plate that you can bolt down! Then you can at least remove it again when you realise you've lost power trying to run this NA

bristol_bb4 · Post by **bristol_bb4** » Wed May 28, 2014 5:40 pm

id be too worried of blowing the welds on the intake

someone had to right?!

mercutio · Post by **mercutio** » Wed May 28, 2014 5:52 pm

bristol_bb4 wrote:id be too worried of blowing the welds on the intake

someone had to right?!

was waiting for that

Post by **NafemanNathan** » Wed May 28, 2014 6:20 pm

Lude Generation

custom h22 intake mani

custom h22 intake mani

Re: Odp: custom h22 intake mani