Lightweight flywheel's

Post by **Thebusofwoe** » Fri Feb 21, 2014 10:33 pm

Has anybody used the F1 racing light weight flywheel????
http://www.tegiwaimports.com/f1-racing- ... ries-1420/
It's cheaper than the Fidanza one which is ?170

. Ordering some bits at payday so I can get this bloody motor in

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Sat Feb 22, 2014 10:38 am

Never heard of 'em?

Tegiwa aren't renowned for customer service btw.

EDIT: fact I've never heard of 'em shouldn't be taken as an opinion that I think that means they're no good! I have no idea on that

If the product's good, then Tegiwa service is a bit irrelevant, it's only if you'd be getting into their customer service.

Post by **Thebusofwoe** » Sat Feb 22, 2014 11:36 am

Yea good point.

Therealjj91 · Post by **Therealjj91** » Sat Feb 22, 2014 12:48 pm

I've got an f1 lightened fly on mine and I've had no problems with it at all.

Post by **Thebusofwoe** » Sat Feb 22, 2014 2:49 pm

Thanks chap. Ok cool, think that's what I'm going to order Friday

JLB · Post by **JLB** » Sun Feb 23, 2014 9:54 pm

Had one of their clutches which lasted the entire length of the test drive after it had been fitted. Supposedly good for 350bhp. Was told after I'd ordered it they were no good. I wouldn't use there stuff again! But that was a clutch and not a flywheel.

Post by **Thebusofwoe** » Sun Feb 23, 2014 10:47 pm

Thanks for the input chap. I will be going with a oem spec exeedy clutch kit with an oem Honda release bearing so will give the flywheel a go.

106pete · Post by **106pete** » Mon Feb 24, 2014 7:35 am

Accord type r oem exedy clutch I hope? Also wasn't the oem exedy slated for not being as good as expected?

Post by **Thebusofwoe** » Mon Feb 24, 2014 7:50 am

Yea was going for the ATR one. Well in not sure. I have one in my civic and has been fine. Still debating weather to go ATR genuine yet.

Post by **Merlin** » Mon Feb 24, 2014 10:30 am

Personally I would just pay the extra wee bit of cash and get the Fidanza.