Euro r inlet on h22a

EG_H22 · Post by **EG_H22** » Sun Oct 06, 2013 8:47 pm

Guys had a hick up on my engine,
Ive fitted the euro r altered the rail and what not but fired the beast up the other day and noticed that there's an air leak.
Where the end bolt is (egr side) theres abit of the block that sticks out poss an oil runner.
Question is did you fellow members that have fitted this what gasket did u use, as was told a thermo one could solve the problem?

Advice needed please

Post by **NafemanNathan** » Sun Oct 06, 2013 9:24 pm

Do you mean the actual EGR port? (About a 10-12mm diameter hole).

EG_H22 · Post by **EG_H22** » Sun Oct 06, 2013 10:07 pm

No the erg bit was so you would know what side im on about, its where you bolt the intake to the head, i seem to have an air leak coming out, wondered if a thermo gasket would sort this as it is thicker than the normal thin gasket, if not just means that ill have to take the i take off and shave abit more off, will have a picture tomorrow night if it helps

Post by **NafemanNathan** » Sun Oct 06, 2013 10:12 pm

It's not the small ports (3mm diameter) in the main flange plate directly above the runner ports is it?

EG_H22 · Post by **EG_H22** » Wed Oct 16, 2013 5:08 pm

Yes mate thats it 4 holes,
Its a bugger now as i got to get the engine out to get to the intake as need to grind abit of the flange for the injectors got about 2" clearance from bulk head as my brake system is in the way,

Post by **NafemanNathan** » Wed Oct 16, 2013 6:34 pm

You can tap those ports with and use grubs screws to block them off. Check out the Rosko-Racing how-to.

EG_H22 · Post by **EG_H22** » Wed Oct 16, 2013 7:12 pm

Yeah wasnt till last night that i was told by my mate that he didnt do that ive got my engine in and running now got to take it apart again

Post by **NafemanNathan** » Wed Oct 16, 2013 9:49 pm

Doh!

EG_H22 · Post by **EG_H22** » Sun Dec 08, 2013 3:59 pm

Right intakes coming off to have some grub screws fitted to do the air leak what size is the diameter of the holes does anyone know

Post by **NafemanNathan** » Sun Dec 08, 2013 8:15 pm

Have you checked Rosko Racing's site? All the info's on there.