Can anyone make these work on a H22?

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Thu Aug 15, 2013 1:20 pm

http://www.ebay.co.uk/itm/Honda-S2000-F ... 4611f6c2f0

Post by **NafemanNathan** » Thu Aug 15, 2013 1:32 pm

Chop down a standard H22 inlet manifold and weld a flange plate on to accept the TB's would be the easiest option. Be cheaper to go for a purpose built OBX job though.

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Thu Aug 15, 2013 1:35 pm

I know, but Jenvey are nice TB's.

106pete · Post by **106pete** » Thu Aug 15, 2013 2:20 pm

Yeah that's easy you just need a adaptor plate made. I think skunk2 make adaptors to fit different manifolds to the h22 so you could try that or get someone to make it

Ted · Post by **Ted** » Thu Aug 15, 2013 2:51 pm

i could get it done but its probably not cost effective.

mercutio · Post by **mercutio** » Thu Aug 15, 2013 9:22 pm

tramroadmotors wrote:i could get it done but its probably not cost effective.

this ^^^^^

and the obx ones look cool

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Thu Aug 15, 2013 10:13 pm

Fair enough, just spotted it while looking for a throttle body on another thread.

106pete · Post by **106pete** » Thu Aug 15, 2013 10:21 pm

You know I can make it cost effective if you wanted them, but I know ud never ditch that charger lol

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Thu Aug 15, 2013 10:32 pm

You thought right!

You can make something else though!