DANS FORGED TURBO BB4

Post by **Thebusofwoe** » Mon Jun 10, 2013 9:53 pm

sensor would have to go after the turbo on the boost side, not sure it matters where

but id say in the manifold somewhere. If there isn't anywhere then id imagine ud have to drill and tap the hole for it

. Is there not a instruction diagram with it? or on the net?

Post by **Thebusofwoe** » Mon Jun 10, 2013 9:57 pm

Oh hang on, Is that a threaded vacuum pipe adapter I see?? if it is, wind the sensor onto that and then plumb it into a vac line with a T piece. DOOOHHHH lol

(me that is)

Post by **ddoubledanny** » Mon Jun 10, 2013 10:12 pm

Thebusofwoe wrote:Oh hang on, Is that a threaded vacuum pipe adapter I see?? if it is, wind the sensor onto that and then plumb it into a vac line with a T piece. DOOOHHHH lol (me that is)

Nice one bud would you know where the best place to tap the T piece is thanks mate

Post by **Thebusofwoe** » Mon Jun 10, 2013 10:56 pm

Well into any vacuum line. Ok so if it was me, id go into the line that serves the Fuel pressure regulator. Do you have any blanked off ports? Or a picture of ur manifold??

Post by **ddoubledanny** » Mon Jun 10, 2013 11:07 pm

I haven't got any good pics of manifold but its a skunk 2 if that helps

I think I may have a blanked of port at the back of the mani

Post by **Thebusofwoe** » Mon Jun 10, 2013 11:13 pm

Yea have a look. I'm thinking you could use the pipe, plum straight onto an empty port and then into the adapter-then sensor. Hope you understand lol

Post by **ddoubledanny** » Mon Jun 10, 2013 11:16 pm

Thebusofwoe wrote:Yea have a look. I'm thinking you could use the pipe, plum straight onto an empty port and then into the adapter-then sensor. Hope you understand lol

I get you just put the boost pipe straight off the blocked port in the back of the mani and then from there to the brass fittings and then that's about it other than power and earth I think lol

Post by **RattyMcClelland** » Mon Jun 10, 2013 11:46 pm

That looks great.

Post by **ddoubledanny** » Mon Jun 10, 2013 11:50 pm

RattyMcClelland wrote:That looks great.

Cheers bud

Post by **Thebusofwoe** » Mon Jun 10, 2013 11:55 pm

Yea that's about it. and wind the adapter onto the sensor lol

Lude Generation

DANS FORGED TURBO BB4

Re: Ddoubles TURBO BB4

Re: Ddoubles TURBO BB4

Re: Ddoubles TURBO BB4

Re: Ddoubles TURBO BB4