Fefelarue's 3rd gen Honda Prelude

Post by **NafemanNathan** » Thu May 23, 2013 5:31 pm

Nice one bud

Does that mean you're likely to have a spare valve cover after the powder-coating?

fefelarue · Post by **fefelarue** » Thu May 23, 2013 6:22 pm

Fraid not bro, just gonna be powdercoating the one i have

Post by **NafemanNathan** » Thu May 23, 2013 7:36 pm

Aww shame. I take it you know to use paint-stripper and not to get it shot blasted?

fefelarue · Post by **fefelarue** » Thu May 23, 2013 7:44 pm

NafemanNathan wrote:Aww shame. I take it you know to use paint-stripper and not to get it shot blasted?

Why's that? I haven't taken it off yet, has it got bits underneath where shizz could get stuck?

Post by **NafemanNathan** » Thu May 23, 2013 8:27 pm

Yeah the baffle plate. It'll be rivetted on so you can't remove it (unless you drill them out and then retap the holes and bolt it back down

), and shot blast will get stuck under it. I've heard of a few engines that have been wrecked because the shot eventually works its way out and into the engine.

fefelarue · Post by **fefelarue** » Thu May 23, 2013 8:29 pm

ooh okay thanks for the info, so if the company can acid dip it or something that would be best i guess?

Post by **NafemanNathan** » Thu May 23, 2013 8:31 pm

Yeah, basically anything that will easily wash/dilute away.

fefelarue · Post by **fefelarue** » Fri May 24, 2013 2:45 pm

Some peeps are still hating on my zorst, so here's a few pics to show you that you're wrong and it's awesome:

Peace out

Post by **NafemanNathan** » Fri May 24, 2013 2:52 pm

From the previous pics it did look either a bit low or that it stuck out too far, but those new pics look spot on

mercutio · Post by **mercutio** » Fri May 24, 2013 4:33 pm

looks like a motorbike can in that pic

Lude Generation

Fefelarue's 3rd gen Honda Prelude

Re: Fefelarue's 3rd gen Honda Prelude

Re: Fefelarue's 3rd gen Honda Prelude

Re: Fefelarue's 3rd gen Honda Prelude

Re: Fefelarue's 3rd gen Honda Prelude