Nitin's SiR Type-S - Last update ever :(

The "S" express · Post by **honda-hardy** » Wed Mar 20, 2013 4:31 pm

come on, man up. you will not brake the studs. as suggested inerlock spanners for leverage is the key.

bb1boy · Post by **bb1boy** » Wed Mar 20, 2013 4:37 pm

To get my hub nut undone I used a nice fat breaker bar but to no avail so I slipped a bit of scaffold pole over it (about 7ft long) and then twisted it off with one hand and zero effort!

nitin_s1 · Post by **nitin_s1** » Wed Mar 20, 2013 5:03 pm

newkid wrote:Seriously how does your car stay on the road? Or is it an ornament that never moves and just looks pretty?

I drive my car on the weekends so it's not a ornament.
It looks pretty.
Just some bits I can't do my self. Not everyone is a mechanic on here.

Thanks for the double spanner idea. I'll give it a go when I'm free after work tomorrow!

Post by **RattyMcClelland** » Wed Mar 20, 2013 5:47 pm

Nitin you fool. 14mm deep socket and a breaker bar, get your gran to push it because your useless and. DONE!

Or if your next near me in Leicester ill do it.

nitin_s1 · Post by **nitin_s1** » Wed Mar 20, 2013 5:54 pm

RattyMcClelland wrote:Nitin you fool. 14mm deep socket and a breaker bar, get your gran to push it because your useless and. DONE!

Or if your next near me in Leicester ill do it.

Will do.

Post by **Donald** » Wed Mar 20, 2013 6:01 pm

1. Get spanner.
2. Point it at the sky.
3."By the Power of Grayskull..."
4. Transform.
5. "...I have the power!"
6. Undo bolts.
7. Bang Teela.

Nik_L · Post by **Nik_L** » Wed Mar 20, 2013 6:06 pm

If its the rear bolt giving him grief, its tight getting a spanner in. There isn't enough room as either the strut top, rear seats, and the car body are all in the way.

Ratty's method works best as it clear the strut top so give's plenty clearance all the way around.

NCCMUR · Post by **NCCMUR** » Wed Mar 20, 2013 8:01 pm

Donald wrote:1. Get spanner.
2. Point it at the sky.
3."By the Power of Grayskull..."
4. Transform.
5. "...I have the power!"
6. Undo bolts.
7. Bang Teela.

8. Then fit brace
9. Bang Teela again

The "S" express · Post by **honda-hardy** » Wed Mar 20, 2013 9:27 pm

i found it easier to remove the rear seat back on my 4th gen to get to the stubborn nut.

LewisH · Post by **LewisH** » Wed Mar 20, 2013 10:26 pm

This is where you need a snapon impact gun

Ive got "wobble bits" as i call them which i use on mine as my cousin done them up a tad tight

Lude Generation

Nitin's SiR Type-S - Last update ever :(

Re: Nitin's SiR Type-S

Re: Nitin's SiR Type-S