Lude Generation

I cant get to the standard jacking points due to the aftermarket side skirts, and they have been moulded to the car so will be a nightmare to get off im thinking.

I need to bleed the brakes so is there anywhere else i can put jack stands to safely keep the car up while i am underneath it?

Cheers.

Towing eye bit if you can reach it, or possibly place something across/between two strong points to spread the load, then jack.

EDIT, didn't read properly No idea about stands.

stands can go under the chassis rails once jacked up

thanks, where are the chassis rails?

either side of the trans/exhaust tunnel look underneath you will see what i mean

OK thanks, will have a look when I have time.


on a side note this is about the most helpful community I have ever come across! I'll try and write some guides for the work I do as a thank you for all the help that has been directed my way.

I use front and rear towing eyes for jacking up.

I then put the axle stands under the subframes.

Gayno wrote:I use front and rear towing eyes for jacking up.

I then put the axle stands under the subframes.

Same here, right where the mounting bolts are, solid as a rock.

another good strong place to jack on or place stands is the anti rollbar d bush clamps that attach the roll bar to the subframe.

Right, i had to jack up the car recently and found what i thought to be the safest points, can you guys just confirm that my car isnt going to fold in half if i have to do it again? lol.

this is where i jacked from (initially where the bolts are until i had enough space to get the stands under the car)

Is that the front towing eye?



And this is where i put the stands.




Is it safe??