Lude Generation

hi has anyone swapped the 4 genfor 5th gen hubs if so are they a direct swop or what
i want some diff wheels but 4 stud is limited

Literally just decided to go that same way yesterday and paid for the necessary bits today

You need 5th gen front knuckles with hubs (Not Type-S) and rear hubs. You'll need to uses washers of a particular size (I don't know what size yet) to space out the front hub nuts so they tighten up properly as well.

Then just swap everything over

wow . i sent you a message re my allos a couple days ago as well great minds an all

As yes, the Nissan GTR-esk wheels

i have been thinking about doing this. not decided fully yet though

why not just upgrade the whole car to a 5th gen? There were many many other improvements made over the 4th, not just the hubs....

clear write up would be handy

dont you need spacers on the hub or something?

Lude-dude wrote:clear write up would be handy

dont you need spacers on the hub or something?

First one to do it gets the honour of doing a write up with pics

And no, it's just a washer that goes over the spline before the hub nut is tightened so as the hub nut doesn't run out of thread. As said though, I'm unsure of the size, but apparently it's not an off-the-shelf-washer, so need to be made up.

And LLL...

well i will hopefully have the parts by the end of January .i mite get the 5th gen shafts aswell but not to sure yet. Still deciding on wheels at the moment as well which could take a while

si import wrote:Still deciding on wheels at the moment as well which could take a while

Tell me about it