Lude Generation

hi just fitted set of oz 17" on my gen 2 and there seem to be a small gap around the central hub what size spigot rings would i need for the lude
here is the image still dont know if i like them or not????

Hmmm... Works on the front, not on the back?

I think?

Or perhaps not?

Your best bet is to get a vernier gauge and measure the gap on the alloys like I had to on mine, the centre bore for 4th and 5th ludes is 64.1 though, the look them up on ebay

hondansxr wrote:what size spigot rings would i need for the lude

For a 2nd gen or 4th gen?

This may help.

http://adaptitusa.com/referencebook.htm

hi
thanks for that

You could PM @Benny as the chances are he will know, but I can guarantee there's no chance he'll see this thread otherwise

Like Taz said, your best and quickest bet is to use a vernier to know for sure

EDIT: Only just seen there's a picture... Which is of a 4th gen, not a 2nd gen. Don't know why it didn't show the first time I looked, but Benny has a 2nd gen which is why a suggested he might know

need to know the center bore of the alloys

wtf I swear the was like one reply in this thread couple of mins ago

There were two identical threads, I merged them