Page 1 of 1
integra/civic front shock forks on a 4th gen?
Posted: Tue May 02, 2017 1:05 pm
by rrobis
hi,
so i've read that chaps used to put teggy front shock forks on prelude to get front slightly lower.
does this applies to Integra only or any civic EG/EK front fork will do?
in theory integra is based on civic and shares lots of components..
Posted: Tue May 02, 2017 5:48 pm
by 4thgenphil
Honestly not worth the effort mate
Re: integra/civic front shock forks on a 4th gen?
Posted: Tue May 02, 2017 5:52 pm
by rrobis
4thgenphil wrote:Honestly not worth the effort mate
Been there done that?
Really it sounds like more pita than the result, just wanted to know if my assumptions were true
Sent from my SM-G925F using Tapatalk
Posted: Tue May 02, 2017 7:45 pm
by 4thgenphil
Its a couple of mm max really. Not a massive pita but a bit of work.
Re: integra/civic front shock forks on a 4th gen?
Posted: Wed May 03, 2017 11:53 am
by rrobis
4thgenphil wrote:Its a couple of mm max really. Not a massive pita but a bit of work.
Ok, thanks for clarification!
Sent from my SM-G925F using Tapatalk
Posted: Thu May 04, 2017 6:20 pm
by Kemp
why not worth ?
you´ll get about 5-7 mm drop for around 10 bucks on the front
Takes about 5 min to modify them, you only have to sand off the fork about 2 mm to make them fit on on the prelude lca
i did it and im happy with it
Posted: Fri May 05, 2017 3:14 pm
by 4thgenphil
Its not that much of a drop if you have them stood next to each other. Its from the centre of the shock locking bolt hole to the lca bolt hole, not the top of the shock fork
Posted: Sat May 06, 2017 2:15 pm
by mercutio
but that will still lower the whole shock??