Lude Generation

Hello all, im new to the forum (preludes altogether really) and the lude iv purchased was on sleeves (horrible things) iv bought some 40mm springs and fitted. However on the n/s front it petrudes through the mount a little further then it should and on both sides it sounds like droplinks have gone. However there wasn't a noise before. Sorry about the rant lol, just need someone with knowledge, and where I can get new at a reasonable price. 5hanks gunny

Sent from my SM-G935F using Tapatalk

Did you message me about the struts on the prelude am breaking?

Well done for changing out the sleeves.

what do you mean when you say "protrudes through the mount further than it should"? Can you post some pics?

For the knocking, are you sure you have re-seated and correctly tightened everything after the change out?

As for new, stock type shocks should be available from the usual suspects (motor factors, eBay etc). There were some delphi struts on eBay pretty cheap, from what I recall and have a look on rockauto.

I agree with Iain. I think some pictures would be helpful to aid diagnosis. Sounds like the top mount may be fitted incorrectly/damaged/worn.

There is always the option to get slightly upgraded shocks to match the lowering springs...

Thanks all for the replies, turns out I missed the inner grommet in the top mount so all good now, iv found some struts (second hand but not leaking) so will get them fitted weekend. Iv only done the front springs and the difference in the ride is unbelievable!! Sleeves are horrendous, but then what do you expect for 50 quid lol. Just glad I have the car now to save her from car Heven because that is where she was headed. As for the mot I think it was a very dodgy one.

Sent from my SM-G935F using Tapatalk

So iv finally finished the shocks and springs front and rear on the car, no more kangaroo lol. However i have noticed that anything above 60 and steering shakes (balancing??) and that she wonders on the road left, and then suddenly right (tracking??) car is on 18s but was never this way on the sleeves? could be because it was so solid? any help is greatly appreciated and will keep her going.

damon wrote:Did you message me about the struts on the prelude am breaking?

i may have done pal, but i have now sorted them lol

Glad you've got the ride and clonking sorted

Shaking at speed could be wheel balancing or drive shaft.

Pulling left/right could be alignment, bushes or track rod ends. Need to get under there and have a good look and prod about.

I had the tracking and balancing done today and she seems better but on different roads she is waiter worse and on others better?


Sent from my iPhone using Tapatalk