Lower ball joint boots

Post by **ADS1** » Sat Mar 31, 2012 9:56 pm

Hi guys.
I have just had my drive shafts off, to replace rubber boots, and also transmission oil seals.
Before dismantling i noticed that my lower ball joint boots are split.
I can get the boots easy enough,but notice in the manual a special tool is needed to fit the circlips during installation. Has anyone ever fitted these, and if so did they manage it without the special tool?
Cheers.
Tony.

jozefsan · Post by **jozefsan** » Sat Mar 31, 2012 10:12 pm

its easy without tool, just be careful to not damage boot