Page 1 of 3

Problem when braking

Posted: Sat Jan 24, 2015 11:08 am
by MaccaIRL
Weird feeling on the brake pedal but only 1/5 times i apply brakes

Feels like abs kicking in but no warning light on dash :/

Mechanic said it was warped discs and low pads so replaced the fronts and its still doing it

Anyone any ideas?
Flew through mot except for 2 upper steering arms (i think) and a balljoint all of which replaced

Car does pull to one side on occasion too but put that down to wheels needing alligned

Thanks in advance

Posted: Sat Jan 24, 2015 11:18 am
by ek9sid
Did you replace the pads or the discs as well?

Posted: Sat Jan 24, 2015 12:18 pm
by vanzep
There is a section in the manual on how to test your brake booster and master cylinder.

Ive had a few issues with brakes and finally sorted it out by fitting a new master cylinder. Had intermittent problem with pedal going to the floor normally in low speed town traffic was down to perished seal(s) in the mc. However my lude is a BB4 with no abs,tcs or 4ws so not a lot to check to find the problem but as your not getting any fault codes/warning lights it could be the same issue.

Posted: Sat Jan 24, 2015 12:19 pm
by mercutio
get the alignment done first then go from there

Posted: Sat Jan 24, 2015 2:41 pm
by hondaman
If it is warped discs the pedal will pulse when you apply the brakes if you just chaged the pads this won't stop the discs being warped , you'll need new discs as well.

Posted: Sat Jan 24, 2015 6:40 pm
by hondansxr
hi does it do it at high speed only or high speed and then when the speed scrubs off it dissipates ?
pulling to one side is caliper not working or low on efficency

Re: Problem when braking

Posted: Sat Jan 24, 2015 7:06 pm
by MaccaIRL
hondaman wrote:If it is warped discs the pedal will pulse when you apply the brakes if you just chaged the pads this won't stop the discs being warped , you'll need new discs as well.
Pads and discs changed on front

And no its just randomly, in traffic at 10mph get it sometimes, at 70mph on motorway i get it sometimes

Only difference / change at all is at higher speeds the bumps or whatever get more rapid... at 10mph you feel like youre in a learner car and they cant use the clutch lol

Its not as bad as it was now i have the warped discs and stuff replaced but its still there

As i said, flew through mot even with this happening so braking efficiency and all is passable

Will check to see if i have the mot slips and post the brake efficiency here

Posted: Sat Jan 24, 2015 7:09 pm
by Vtecmec
Pull the ABS fuse to disable it to see if it is the ABS kicking in or whether it's a mechanical issue.

Re: Problem when braking

Posted: Sat Jan 24, 2015 7:13 pm
by MaccaIRL
Brake efficiency at mot before pads and discs changed

Axle 1 (sb)
N/S 3.24 kN
O/S 3.51kN

Imbalance 8%

Brake fluctuation
N/S - 6%
O/S - 9%

Posted: Sat Jan 24, 2015 7:51 pm
by ek9sid
Did you change the rear pads and discs?