Lude Generation

Hi, just need help with the sizes.will these go on too a 5thgen????

4x114.3 17x9 75j. Et 25 maybe. Checking to confirm this.

Thanks

Only a 2.0 litre. 2.2 are 5X114.3

17x9.75 ET25? Gonna need to bend some metal

I would think these might foul the inside of the wheel arch. Check some of the US forums as I've seen people with 9J and 10J offsets but you normally need a fair bit of fender work to make it happen if it is lowered.

I've just fit 17x8J (+40) with the standard 215/45/R17 tyres and they fit fine with stock Motegi springs.

honda-hardy wrote:Only a 2.0 litre. 2.2 are 5X114.3

Yeah it's a 2 litre matey.

Spydor, it's lowered 40mm already and the tyres on the rims are 225/45 all round. Will check the us forums cheers.

Oh and the offset may be lower. Lmao

drift it wrote:

honda-hardy wrote:Only a 2.0 litre. 2.2 are 5X114.3

Yeah it's a 2 litre matey.

Spydor, it's lowered 40mm already and the tyres on the rims are 225/45 all round. Will check the us forums cheers.

Oh and the offset may be lower. Lmao

Trust me when i say they wont fit.

9" wheels and offsel below 45 you will need to roll the arches. Offset above 45 and you will rub on the suspension arm.
9.75" wheels will need a pull and a roll.

To backup what Ratty says check out this site, gives you a bit of a visual comparison of alloy and tyre sizes:
http://www.willtheyfit.com

If you put your existing vs the new size you will see the inner clearance will probably be okay but they stick out miles further past the arches, so there is no way it would fit on a lowered ride without some serious work.

Yeah, there gonna be a little bit more work than I'd like.oh well, best keep on looking Cheers all.

Where are they mate, depends on the details I may be interested

4thgenphil wrote:Where are they mate, depends on the details I may be interested

Over on Driftworks buddy,wheels and tyres for sale, seller is initial j. Bought stuff off him before and he's spot on.

The wheels are XXR 527