Recommend me some wheels

nitin_s1 · Post by **nitin_s1** » Sat Aug 18, 2018 1:52 pm

Who else has a “S-Spec” that’s Phoenix yellow ?

Post by **tom023** » Sat Aug 18, 2018 5:33 pm

nitin_s1 wrote:Who else has a “S-Spec” that’s Phoenix yellow ?

Nobody that I can think of. 'twas a joke seeing as he was looking at your build for inspiration

Sent from my Redmi Note 4 using Tapatalk

ATR84 · Post by **ATR84** » Mon Aug 20, 2018 2:37 pm

So, I am leaning towards Rota Torque's in bronze. The car is white. Thoughts?

Also, should I go 16 inch or 17 inch? Assuming there is no real performance difference between the two, I want it to look the part. The car will be lowered on coilovers at the same time. This is the car

- https://torque-gt.co.uk/car/honda-prelude-type-s/

Post by **NafemanNathan** » Mon Aug 20, 2018 3:13 pm

I like dark bronze on white. Much better than silver, black or gunmetal on white in my opinion.

And I personally prefer 17's on a 5th gen.

Post by **RattyMcClelland** » Mon Aug 20, 2018 3:16 pm

I say silver on a white 5th gen. Matt black or bronze also work. Pure flat white doesn't as it the car is pearl white and much more yellow. Get pearl white wheels if white.

ATR84 · Post by **ATR84** » Mon Aug 20, 2018 3:36 pm

Thanks both, and the size and offset would be: 17 x 7.5”, ET45 would this be ok? And should I put 215 or 225 wide tyres on them?! Sorry about all the questions and thank you for your help, this forum is really friendly so thanks again

Post by **NafemanNathan** » Mon Aug 20, 2018 3:38 pm

That size and offset is fine. You may want to space them out a tad if anything.

And 215/45r17 is the closest to stock.

225/40 are harder to find and 225/45's are a fair bit oversized.

ATR84 · Post by **ATR84** » Mon Aug 20, 2018 3:45 pm

NafemanNathan wrote: 17 x 7.5”, ET45

To save getting spacers, should I go for a different size? If so what would you recommend?

Post by **NafemanNathan** » Mon Aug 20, 2018 3:49 pm

I run 8" wide et43, so to replicate that in 7.5" you'd need to be et37. You could afford to go down to et35.

ATR84 · Post by **ATR84** » Mon Aug 20, 2018 3:59 pm

NafemanNathan wrote:I run 8" wide et43, so to replicate that in 7.5" you'd need to be et37. You could afford to go down to et35.

That's interesting, earlier in this thread Merlin stated:

"I have ET45 on my 5th gen which only just rubs on the tabs on the rear bumper", wouldn't this mean that et37 would stick out? I am going to lower the car on coilovers but I don't want to roll the arches or start cutting away at any of the bumper.

Lude Generation

Recommend me some wheels

Re: Recommend me some wheels