steering rack - inner tie rods

mercutio · Post by **mercutio** » Sun Feb 08, 2015 12:02 pm

new old stock

Post by **ek9sid** » Sun Feb 08, 2015 12:24 pm

Ahh thank you

Post by **vanzep** » Tue Feb 10, 2015 5:37 pm

just to update - the QH parts dont fit

the thread that goes into the rack is too big

guess they will have to go back.

good new was ive had the old inner tie rods cleaned up and now the alignment can be done

no wait a minute there is excessive lift on the drivers side front ball joint and the boot is split so thats got to be replaced first

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Tue Feb 10, 2015 7:44 pm

Don't fit?

what a complete arse...

Post by **vanzep** » Wed Feb 11, 2015 2:51 pm

yep bit annoyed about this - i checked with them (redline on ebay) and gave them reg no etc before ordering the parts

parts are listed as fitting 4th gen Vtec