custom h22 intake mani
Posted: Tue May 27, 2014 10:17 pm
I suppose it might be ok for small boost but will lose power without a map n/aPage 1 of 1
Posted: Tue May 27, 2014 10:21 pm
I suppose it might be ok for small boost but will lose power without a map n/aPosted: Wed May 28, 2014 12:12 am
Looks like a lot of effort when you should just fit a skunk or ATR one instead? Re: Odp: custom h22 intake mani
Posted: Wed May 28, 2014 4:37 am
ATR manifold also require some work before it is fitted
Posted: Wed May 28, 2014 4:22 pm
Why on earth would you weld that direct to the IM lower?! Weld it to a flange plate that you can bolt down! Then you can at least remove it again when you realise you've lost power trying to run this NA 
Posted: Wed May 28, 2014 5:40 pm
id be too worried of blowing the welds on the intake
someone had to right?!
someone had to right?!
Posted: Wed May 28, 2014 5:52 pm
was waiting for thatbristol_bb4 wrote:id be too worried of blowing the welds on the intake
someone had to right?!
Posted: Wed May 28, 2014 6:20 pm