Lude Generation

I bought this from Pete (106Pete).

Great quality and great welding.

It was for my Type-S but I think it will fit on most 5G (or JDM cars).

It's 2.5" in diameter.







£50 pick up or £60 delivered.

Just like to add.

The only reason I'm selling is because I will be getting a full exhaust done through Solid-Fab.

Is it 25.5 or 26.5cm long?

Merl, just measured it..

It's 26cm.

I would measure it again as LG sources say the Type-S decat is 25.5 and a regular JDM decat is 26.5 In the pic above it it looks like it would be 25.5.

There's 2 angles on the flanges so not easy to give a exact measurement, these were a exact copy of the 4g jdm cat and fitted quite reasonably to a type s, the main difference being the mani has more angle but didn't prove to be an issue.

106pete wrote:There's 2 angles on the flanges so not easy to give a exact measurement, these were a exact copy of the 4g jdm cat and fitted quite reasonably to a type s, the main difference being the mani has more angle but didn't prove to be an issue.

Yes. Different flanges so hard to measure it.



But good news is that this will fit a 4G JDM perfect.

If u think 5 to 10 mm in length will affect what its doing or how its going to fit u need to give your head a shake hahaha he has done a good job on that so y complain ? If the flanges are in the correct place jobs a good one

leefentonsheard wrote:If u think 5 to 10 mm in length will affect what its doing or how its going to fit u need to give your head a shake hahaha he has done a good job on that so y complain ? If the flanges are in the correct place jobs a good one

If only everything worked under the same theory. I'm sure your Mrs would appreciate it if you had an extra 5-10mm.

Are you speaking from experience there Donald?