Page 1 of 1
Can I use Auto Drive Shafts on Manual ?
Posted: Mon Apr 30, 2018 8:00 am
by uberNoobZA
Can I use the drive shaft from an automatic 4th gen on a manual 4th gen (specifically a 1995 2.2 VTEC) ?
Posted: Mon Apr 30, 2018 8:32 am
by Vtecmec
You can on the off side.
Posted: Mon Apr 30, 2018 9:10 am
by uberNoobZA
Vtecmec wrote:You can on the off side.
Damn - I need it on the near side (left)
Thanks
Posted: Mon Apr 30, 2018 2:10 pm
by Vtecmec
Typical. The autos have no intermediate shaft like the manuals,, so it's super long in comparison to the manual. The cv joints would all mate up,, so if you've a broken manual cv joint they can be swapped between shafts.
Posted: Tue May 01, 2018 12:29 pm
by mynameisowen
I had prpblems doing exactly this on a 5G, the shafts where ever so slightly different lengths requiring a spacing washer to actually preload the bearing. Would avoid....