Clutch problems - slave cylinder or not?? - need advice plz

snike77 · Post by **snike77** » Sun Sep 14, 2014 11:08 am

Broke down yesterday, clutch seemed to be sticking slighty on release for a few miles, hadnt done that at all until yesterday,

Then all of a sudden at a juction, pedal stayed at the floor, obviously could not get into gear

Called aa for recovery, the guy spotted fluid leaking from clutch slave cylinder when pumping the pedal, so that seems to be the fault he thinks

I was just wondering if that sounds like thats the only problem, or whether there are any other issues that may/could be the cause??

Any help much appreciated, thanks

Post by **Thebusofwoe** » Sun Sep 14, 2014 11:41 am

Yea I would go with the slave cylinder matey. Pretty common. Not expensive and easy to fit.

Post by **Thebusofwoe** » Sun Sep 14, 2014 11:42 am

Also check under the clutch pedal. Just make sure you haven't got fluid leaking from the master cylinder too.