Lude Generation

Trying to replace my rocker cover gasket today, & I've only gone & ducked it up before I've even started!

Was trying to disconnect this breather pipe from the rocker cover, & the plastic bend just disintegrated.





How catastrophic is this please, and what are my options?

Thanks in advance.

@honda-hardy, @RattyMcClelland, @wurlycorner, @tramroadmotors, @NafemanNathan?

Looks like there is enough of the pipe from the block left that you can fix the breather hose onto - use a bit of sealant if you want.

Cheers mate, also do these spark plug seals look drokked to you?

Whole reason I'm changing the gasket is because I was getting oil down the spark plug threads..

You need a new pcv valve. A h22 one will fit. body lemonade easy.

Cheers Ratty. In the temporary short-term, and in the absence of a replacement PCV valve, what are my immediate options would you say? What Vanzep suggested?

you need to repalce the spark plug o rings - the one there look knackered
if ratty says H22 pcv valve will fit then thats good - you should be able to pick one up easy

I can stick one if them in the post for you pm me your address. Use sime silicine as a temp measure on your gasket

Indeed. I only need this engine to run successfully till the end of March, when I have the conversion done. So in the immediate short-term, and in the absence of replacement o-rings, will a tiny ring of this sealant round each I-ring do the job for now?

tramroadmotors wrote:I can stick one if them in the post for you pm me your address. Use sime silicine as a temp measure on your gasket

Cheers mate. How should I fix this PCV valve for now though, to keep me mobile?