H22A7 ATR inlet manifold + Hondata S300 + 68mm TB

Post by **NafemanNathan** » Sat Jul 14, 2018 12:44 pm

louckie wrote:Little update

Purchased black world Racing 68mm throttle body

Purchased ATR INLET

Purchased Hondata S300 V2 with obd1 to obd2a harness

Now my questions are.....

Do I have to run an EGR valve and the runner plate or can I blank it all ?

What injectors do I run..... ATR head and ATR injectors ? Although I’ve already tapped the holes to plug the secondary air feed for injectors ???...

As far as I’m away I have to run a 2 wire Iacv is there a walk through on this anywhere thanks in advance

Only just seen this thread Louckie. Have you got all your answers?

louckie · Post by **louckie** » Sun Jul 15, 2018 11:38 am

NafemanNathan wrote:
louckie wrote:Little update

Purchased black world Racing 68mm throttle body

Purchased ATR INLET

Purchased Hondata S300 V2 with obd1 to obd2a harness

Now my questions are.....

Do I have to run an EGR valve and the runner plate or can I blank it all ?

What injectors do I run..... ATR head and ATR injectors ? Although I’ve already tapped the holes to plug the secondary air feed for injectors ???...

As far as I’m away I have to run a 2 wire Iacv is there a walk through on this anywhere thanks in advance
Only just seen this thread Louckie. Have you got all your answers?

Yeah mate just sent it and bolted it all up and hoped for the best.

Starts drives and done a track day at Snetterton so as a guess I’d say it’s proably alright

Post by **NafemanNathan** » Sun Jul 15, 2018 2:53 pm

Great