Limp mode h22

jonja · Post by **jonja** » Wed Oct 08, 2014 10:57 am

Cambelt was done about 6 months ago and yes i did replace autotensione

Yes check engine light stays constantly on

I will check ecu connections one more time.

Post by **Merlin** » Wed Oct 08, 2014 11:03 am

If the check engine light is on I would try and get the code again. Only once has my 5th gen gone into limp mode. The code it gave me was for air intake temp.

jonja · Post by **jonja** » Wed Oct 08, 2014 12:28 pm

Just started it and everything works i dunno what was wrong but it woorks!!!!
Thanks everyone for help

Post by **Merlin** » Wed Oct 08, 2014 1:11 pm

Still pull the code and see what the problem was

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Wed Oct 08, 2014 1:15 pm

I assume it's rained up there recently (like everywhere)?
So... water in a connection somewhere in the engine bay would be a possible.
Suggest you take them all apart one by one, make sure they were all fully home and check the seals are all in place, contacts are clean and not corroded etc.

Lude Generation

Limp mode h22

Re: Limp mode h22

Re: Limp mode h22